?

Log in

No account? Create an account

Previous Entry | Next Entry

Sweeney todd razor

Here is a picture of the razor i am doing for a precocious moments Sweeney Todd. The razor part is actually silver on both sides. In other words it will be able to take and actually be seen on both siades. My one thought is how am i going to be able to take and actually allow it to be able to move and be a real working fake...

Comments

( 2 comments — Leave a comment )
drpaisley
Feb. 24th, 2008 09:27 pm (UTC)
Put it on much heavier material (carolina board, for example) and then use a rivet or something to put the pieces together but allow the blade to pivot. You'll also need some material between the two halves of the handle on the back side so the blade doesn't come out that way (or at least a couple of stops to hold it in). Although being able to spin the blade through the handle to make it a "rotating knife" would be cool, too.
jimmy_hollaman
Feb. 25th, 2008 01:10 am (UTC)
see the thing is i need it to be flat still. I have seen a rivot system for people that do scrap booking, i hope that it would work thin enough so that it can work still but be thin enough to use under glass. (as this will go in my typical frame work) might just have it set up so it could work if you put a rivot in to it....
( 2 comments — Leave a comment )

Profile

Uncle Duke
jimmy_hollaman
Jimmy Hollaman and GUS
Website

Latest Month

April 2018
S M T W T F S
1234567
891011121314
15161718192021
22232425262728
2930     

Page Summary

Powered by LiveJournal.com
Designed by chasethestars